Submersible Pumps 6”Submersible Pumps 6”McKarlen is one of the main manufacturer of Deep Well Submersible Pumps made of high quality stainless steel for bore holes. Special design on the impeller and diffuser make this pump resistant to sands for up to 1%. The state of the art design is very energy efficient and offer a high performance pumping therefore easy installation and low maintenance costs.S000043Submersible Pumps0đQuantity: 0 cái


  •  
  • Submersible Pumps 6”

  • Post on 06-09-2017 08:45:51 PM - 367 Views
  • Product code: S000043
  • Price: 0 đ

  • McKarlen is one of the main manufacturer of Deep Well Submersible Pumps made of high quality stainless steel for bore holes. Special design on the impeller and diffuser make this pump resistant to sands for up to 1%. The state of the art design is very energy efficient and offer a high performance pumping therefore easy installation and low maintenance costs.


Basic Features

• Corrosion resistant, Non-polluting, stainless steel construction — inside and out.
• Built-in jam-free stainless steel check valve will effectively prevent backflow of water in the pipe from affecting pump performance when the motor is not operating.
• Precision stainless steel intermediate chamber can help maintain optimum performance even when pressure is greatest.
• The high-performance, highly efficient stainless steel impellers are one of the special features of McKarlen submersible pump. It is incomparably superior to ordinary plastic or brass impellers in terms of abrasion resistance and service life.
• The stainless steel strainer can prevent the entry of sand or other extraneous material. The smooth safety hook will prevent the cable from abrading.

Application

• Supply of raw water for households
• Supply of water from the wells to the reservoir
• Irrigation, Plantation and Agriculture
• Industrial and municipal application

Rewindable Motors

Features

• Conform to international standard of IEC34-1,CE, whole blocked asynchronous motor with squirrel cage rotor.
• Outer shell, shaft and bottom made of stainless steel.
• Brass alloy or Nickel plated cast-iron upper bracket.
• Swedish bearing or equivalent products can undertake higher thrust load
• Italian mechanical seal.
• Pressure automatic adjusting device made of oilproof and waterproof reformed butyl rubber.
• Flange connector conform to the standard of NEMA (USA National Electrical Manufacturing Association).
• Lacquer-coated wire conforms to USA standard of NEMA MW37-C.

Materials

• high-quality cold-rolled silicon steel lamination.
• Special mechanical seal design.
• 220°C-resistant lacquer-coated wires.
• high-quality bearing undertaking big thrust load.

General Curves SP Web

  Reader Comments

     

 

Products in this Category

 

KEEP UP TO DATE

Subscribe to our event update e-newsletters if you would like to be kept up-to-date about McKarlen events, including our technical article and conferences.
You did not use the site, Click here to remain logged. Timeout: 60 second